LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Interior Trim.
    2. Fig 1: Blower Motor Resistor
    GM759902Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the blower motor resistor electrical connector (3).
  3. Remove the blower motor resistor mounting screws (2).
  4. Remove the blower motor resistor (1).
scientia non olet · About LEMON Manuals