Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor

Courtesy of GENERAL MOTORS CORP.

Install the blower motor (2).
Install the blower motor cooling tube.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the blower motor mounting screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Connect the blower motor electrical connector.
Install the right closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Interior Trim.