LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Air Temperature Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Temperature Door
    GM735973Courtesy of GENERAL MOTORS CORP.
  1. Install the air temperature door (1) to the lower module half.
  2. Assemble the HVAC module case halves.
  3. Install the mode actuator.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws to the mode actuator.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  5. Install the air temperature actuator.
  6. Install the screws to the air temperature actuator.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

    7. Fig 2: HVAC Module Assembly Halves
    GM741189Courtesy of GENERAL MOTORS CORP.
  7. Install the screws in order to assemble the HVAC module.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  8. Install the HVAC module assembly (1). Refer to HVAC Module Assembly Replacement .
scientia non olet · About LEMON Manuals