LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Air Outlet Replacement - Instrument Panel - Center >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Outlet/Inlet
    GM957231Courtesy of GENERAL MOTORS CORP.
  1. If reinstalling the original outlet, install the air deflectors in the outlet. Refer to Air Outlet Replacement - Instrument Panel .
  2. Install the outlet assembly to the I/P.
    3. Fig 2: Screws At Bottom Of Air Outlet Assembly
    GM957271Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 2 retaining screws (1).

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the radio. Refer to RADIO REPLACEMENT in Entertainment.
  5. Install the I/P cluster bezel, Chevrolet only. Refer to BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (CHEVROLET) or BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (GMC/OLDSMOBILE) in Instrument Panel, Gages, and Console.
  6. Install the knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER Instrument Panel, Gages, and Console.
  7. Install the left closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals