Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the floor air outlet duct (1) into position.
- Install the floor air outlet duct retaining push pin (2).
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
- Install the LH lower closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT in Instrument Panel, Gages and Console.
NOTE:
Refer toFASTENER NOTICE
in Cautions and Notices.