LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer toLIFTING AND JACKING THE VEHICLE in General Information.
  2. Disconnect the electrical connector from the A/C refrigerant pressure sensor. The connector is accessible through the lower control arm.
    3. Fig 1: A/C Refrigerant Pressure Sensor
    GM735912Courtesy of GENERAL MOTORS CORP.
  3. Remove the A/C refrigerant pressure sensor from the compressor hose block.
  4. Remove and discard the O-ring seal from the A/C refrigerant pressure sensor.
scientia non olet · About LEMON Manuals