LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seal to the air inlet grille panel.
  2. Install the rear hood seal to the air inlet grille panel studs.
  3. Close the hood.
    Fig 1: Locating Air Inlet Grille Panel/Hood Seal
    GM742164Courtesy of GENERAL MOTORS CORP.