LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Hood Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hood to the vehicle with an assistant.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Partially install the 4 bolts (2) that retain the hood to the hinges (3).
  3. Position the hood to the hinges at the previously marked locations with an assistant.

    Tighten:  Tighten the hood retaining bolts to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Hood Hinges & Retaining Bolts
    GM740670Courtesy of GENERAL MOTORS CORP.
  4. Install the hood insulation to the hood.
  5. Install the push-pin retainers (2).
    6. Fig 2: Removing/Installing Hood Push-Pin Retainers
    GM743495Courtesy of GENERAL MOTORS CORP.
  6. Install the underhood lamp wiring harness to the hood and hinge as previously routed.
  7. Install the underhood lamp to the hood by seating the retaining tabs.
  8. Connect the electrical connector (1) to the underhood lamp.
    Fig 3: Disconnecting/Connecting Underhood Lamp Electrical Connector
    GM740912Courtesy of GENERAL MOTORS CORP.
  9. Install the ground terminal retaining bolt (1) to the hood.

    Tighten:  Tighten the hood ground terminal bolt to 10 N.m (7 lb ft).

    Fig 4: Removing/Installing Ground Terminal Retaining Bolt
    GM740913Courtesy of GENERAL MOTORS CORP.
  10. Install the front hood molding. Refer to MOLDING REPLACEMENT - HOOD FRONT in Exterior Trim.
scientia non olet · About LEMON Manuals