LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Hood Latch Support Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood latch support to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts that retain the hood latch support to the radiator support.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    Fig 1: Removing/Installing Hood Latch Support Retaining Bolts
    GM749967Courtesy of GENERAL MOTORS CORP.
  3. Install the hood latch. Refer to Hood Latch Replacement  .
  4. Install the headlamp housing panel. Refer to Headlamp Housing Panel Replacement (Chevrolet, GMC)  or Headlamp Housing Panel Replacement (Oldsmobile)  .
  5. Install the radiator air intake baffle. Refer to Air Intake Baffle Replacement - Radiator  .
scientia non olet · About LEMON Manuals