LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Hood Latch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the grille. Refer to GRILLE REPLACEMENT (GMC) or GRILLE REPLACEMENT (CHEVROLET) or GRILLE REPLACEMENT (OLDSMOBILE) in Exterior Trim.
  2. Using a grease pencil or other suitable marking device, mark the location of the latch on the mounting bracket.
  3. Remove the bolts that retain the latch to the mounting bracket.
    4. Fig 1: Removing/Installing Hood Latch-To-Support Bracket & Bolts
    GM749964Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the hood latch cable from the latch.
    Fig 2: Disconnecting/Connecting Hood Latch Cable To Latch
    GM742161Courtesy of GENERAL MOTORS CORP.
  5. Remove the latch from the vehicle.
scientia non olet · About LEMON Manuals