LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hinge(s) (3) to the body as previously marked.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts (2) that retain the hinge(s) to the body.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Hood Hinges & Retaining Bolts
    GM740670Courtesy of GENERAL MOTORS CORP.
  3. Install the hood. Refer to Hood Replacement  .
scientia non olet · About LEMON Manuals