LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Brace Replacement - Radiator Support Diagonal >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radiator support diagonal brace to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts that retain the radiator support diagonal brace.

    Tighten:  Tighten the radiator support diagonal brace to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Radiator Support Diagonal Brace
    GM750114Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals