LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement (Envoy, TrailBlazer) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. Refer to WIPER ARM REPLACEMENT in Wiper/Washer Systems.
  2. Remove the air inlet grille panel retaining nuts.
  3. Remove the air inlet grill panel push-pin retainers.
    Fig 1: Removing/Installing Air Inlet Grille Panel Push-Pin Retainers
    GM742164Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the washer hose.
  5. Remove the air inlet grille panel from the vehicle, by pulling upwards in order to disengage the retaining clips.
  6. Place the air inlet grille panel on a clean, prepared surface.
  7. Remove the rear hood seal from the air inlet grille panel studs.
scientia non olet · About LEMON Manuals