LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Analog Instrument Panels) >> Removal & Installation >> Door Lock >> Removal (Front Door - Monte Carlo)

Removal (Front Door - Monte Carlo)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: This vehicle has energy-absorbing foam blocks for side impact protection. To help avoid personal injury in a collision, foam blocks that are damaged, or removed during repairs must be replaced. Failure to replace foam blocks that are removed can violate federal law.
  1. Position window completely up. Remove screw from upper door trim panel. Remove screws from door pull handle. Remove inside door handle bezel screw. Remove inside door handle bezel from door trim panel. Remove power door lock switch from inside door handle bezel using a small, flat-blade tool in order to release retainers. Disconnect electrical connector from power door lock switch.
  2. Remove inside door handle bezel from vehicle. Support door trim panel until power mirror switch and/or power window switch is removed. Remove door trim panel from door inner panel using door trim clip tool in order to disengage fasteners from door inner panel.
  3. Disconnect power mirror switch by pressing thumb tab retainers outward and remove switch from pull handle. Remove window switch by pressing thumb tab retainers outward and remove switch from pull handle.
  4. Disconnect all required electrical connectors. Remove inside door handle gasket. Remove door water deflector from door inner panel. Remove door energy absorber pad clip (on top) from front door. Remove inner energy absorber.
  5. Remove door inside handle rods from door inside handle. Remove window channel retainer screw. Remove window channel from door. Remove clip securing inside handle rods to door. Remove outside handle rod-to-lock clip from lock.
  6. Remove screws securing lock to front door. Remove door lock from door with inside door handle rods attached to lock. Disconnect electrical connectors. Remove door inside door handle rods from door lock.
scientia non olet · About LEMON Manuals