LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1697 (Tires & Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spare wheel hoist assembly to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install spare wheel hoist assembly mounting bolts to the frame

    Tighten:  Tighten the spare wheel hoist assembly mounting bolts to the frame to 50 N.m (37 lb in).

    Fig 1: Removing/Installing Spare Tire Hoist Assembly Mounting Bolts From Frame
    GM749244Courtesy of GENERAL MOTORS CORP.
  3. Install the spare tire to the spare tire carrier.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals