Inspection Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle with safety stands. Refer to LIFTING AND JACKING THE VEHICLE
in General Information.CAUTION: Wear gloves when inspecting the tires in order to prevent personal injury from steel belts sticking through the tire.
- Perform the following preliminary inspection:
- Mark the tire with a crayon in order to note the start and the stop position.
- Rotate each tire and wheel by hand.
- Inspect the tire for bulges or bent wheels. Replace as necessary.
- Use tire substitution in order to identify the faulty tire. Perform the following steps for a tire substitution check:
- Use a comparable tire in order to replace each tire, one at a time.
- Test drive the vehicle.
- If the problem is tire or wheel related, you will eliminate the problem when you remove the faulty tire from the vehicle.