LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the tire and the wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the rotor. Refer to FRONT BRAKE ROTOR in Disc Brakes.
    IMPORTANT: Do not hammer on a wheel stud.
  4. Remove the wheel stud bolt using J 43631  . See Special Tools and Equipment .
    5. Fig 1: Removing Wheel Stud From Axle Flange
    GM649304Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals