LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Wheel Hub, Bearing, and Seal Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the brake rotor. Refer to FRONT BRAKE ROTOR in Disc Brakes.
  4. Remove the ABS sensor mounting bolt from the wheel hub and bearing.
    Fig 1: Removing/Installing Wheel Speed Sensor Mounting Bolt
    GM743104Courtesy of GENERAL MOTORS CORP.
  5. Remove the ABS sensor from the wheel hub and bearing.
  6. Remove the wheel hub and bearing to the steering knuckle mounting bolts.
    Fig 2: View Of Wheel Hub And Bearing Mounting Bolts (RWD)
    GM750558Courtesy of GENERAL MOTORS CORP.
  7. Remove the wheel hub and bearing from the steering knuckle.
    Fig 3: Identifying Wheel Hub
    GM750559Courtesy of GENERAL MOTORS CORP.
  8. Remove the splash shield from the steering knuckle.
scientia non olet · About LEMON Manuals