LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Upper Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the steering knuckle with wheel hub attached. Refer to Steering Knuckle Replacement (RWD)  or Steering Knuckle Replacement (4WD) .
  4. Remove the upper ball joint retaining clip.
    Fig 1: View Of Upper Ball Joint Retaining Clip
    GM744335Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper ball joint boot.
  6. Remove the upper ball joint from the steering knuckle using J 9519-E .
    Fig 2: Removing Upper Ball Joint From Steering Knuckle
    GM744330Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals