LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Upper Ball Joint Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper ball joint to steering knuckle using J 9519-E , J 21474-01  and J 45117  . See Special Tools and Equipment .
    Fig 1: Installing Upper Ball Joint From Steering Knuckle
    GM744332Courtesy of GENERAL MOTORS CORP.
  2. Install the upper ball joint retaining clip.
    Fig 2: View Of Upper Ball Joint Retaining Clip
    GM744335Courtesy of GENERAL MOTORS CORP.
  3. Install the steering knuckle with wheel hub attached. Refer to Steering Knuckle Replacement (RWD)  or Steering Knuckle Replacement (4WD) .
  4. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  5. Lower the vehicle.
  6. Check the front wheel alignment. Refer to WHEEL ALIGNMENT .
scientia non olet · About LEMON Manuals