LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulator to stabilizer shaft with slit facing the front of the vehicle.
  2. Install the stabilizer shaft insulator clamp to the stabilizer shaft insulator.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Removing/Installing Stabilizer Shaft Insulator Clamp Mounting Bolts
    GM731561Courtesy of GENERAL MOTORS CORP.
  3. Install the stabilizer shaft insulator clamp mounting bolts.

    Tighten:  Tighten the stabilizer shaft insulator clamp mounting bolts to 55 N.m (41 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals