LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1696 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower ball joint and J 9519-E , J 41435  , and J 45105-2  to the lower control arm. See Special Tools and Equipment .
    Fig 1: Installing Lower Ball Joint
    GM751170Courtesy of GENERAL MOTORS CORP.
  2. Install the lower ball joint to the lower control arm using J 9519-E , J 41435  , and J 45105-2  . See Special Tools and Equipment .
  3. Remove J 9519-E , J 41435  , and J 45105-2  from the lower control arm. See Special Tools and Equipment .
  4. Install J 9519-E and J 45105-1  to the lower ball joint. See Special Tools and Equipment .
  5. Flare the lower ball joint flange using J 9519-E and J 45105-1  . See Special Tools and Equipment .
    Fig 2: Flaring Lower Ball Joint Flange
    GM754744Courtesy of GENERAL MOTORS CORP.
  6. Remove J 9519-E and J 45105-1  from the lower ball joint. See Special Tools and Equipment .
  7. Install the steering knuckle with wheel hub and bearing attached. Refer to Steering Knuckle Replacement (RWD)  or Steering Knuckle Replacement (4WD) .
  8. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  9. Lower the vehicle.
  10. Check the front wheel alignment. Refer to WHEEL ALIGNMENT .
scientia non olet · About LEMON Manuals