LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Wheel Opening Door Flare Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Be careful not to scratch or chip the paint.
  1. Remove the molding from the vehicle using the following procedure:
    1. Heat the wheel opening molding using a J 25070  . Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for about 30 seconds.

    2. Peel the wheel opening molding from the panel surface using a flat-bladed tool.
    Fig 1: Removing/Installing Rear Wheel Opening Door Flare
    GM752102Courtesy of GENERAL MOTORS CORP.
  2. Remove all adhesive from the body panel and the back of the wheel opening molding using a 3M(tm) scotch brite molding adhesive remover disk 3M(tm) P/N 07501 or equivalent.
  3. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals