LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Rocker Molding Scuff Plate Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear door.
  2. Remove the push-pin that retains the rear rocker molding scuff plate to the rocker panel.
  3. Lift upwards on the scuff plate to release the retaining tabs.
    Fig 1: Removing/Installing Rear Rocker Molding Scuff Plate
    GM750775Courtesy of GENERAL MOTORS CORP.
  4. Remove the scuff plate from the vehicle.
scientia non olet · About LEMON Manuals