LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel Rear >> Removal Procedures

Removal Procedures

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rocker panel assembly. Refer toMolding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada)  or Molding Replacement - Rocker Panel (TrailBlazer EXT, Envoy XL)  .
  2. Remove the door opening screws (1) from front of rocker panel rear molding.
    Fig 1: Removing/Installing Rocker Panel Rear Molding Screws & Push-In Retainers
    GM831869Courtesy of GENERAL MOTORS CORP.
  3. Release push-in retainers (2) using a trim removal tool.
    NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  4. Remove the rocker panel molding from the rocker panel.
scientia non olet · About LEMON Manuals