LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker molding to the holes in the rocker panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the door opening screws (1).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    Fig 1: Removing/Installing Rocker Panel Rear Molding Screws & Push-In Retainers
    GM831869Courtesy of GENERAL MOTORS CORP.
  3. Install push-in retainers
scientia non olet · About LEMON Manuals