LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Front  .
  2. Remove the rear rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Rear  .
  3. Remove the assist step. Refer to ASSIST STEP REPLACEMENT in Frame and Underbody.
  4. Remove the rocker panel molding bolts located at each end of the rocker panel molding.
    Fig 1: Removing/Installing Rocker Panel Molding Bolts
    GM742127Courtesy of GENERAL MOTORS CORP.
  5. Use the J 36796  in order to remove the 7 push-pins that retain the bottom of the rocker panel molding to the body.
  6. Remove the rocker panel molding from the vehicle.
scientia non olet · About LEMON Manuals