LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker panel molding to the body.
  2. Install the 7 push-pins that retain the bottom of the rocker panel molding to the body.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the rocker panel molding bolts located at each end of the rocker panel molding.

    Tighten:  Tighten the rocker panel molding bolts to 7 N.m (62 lb ft).

    Fig 1: Removing/Installing Rocker Panel Molding Bolts
    GM742127Courtesy of GENERAL MOTORS CORP.
  4. Install the assist step. Refer to ASSIST STEP REPLACEMENT in Frame and Underbody.
  5. Install the front rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Front  .
  6. Install the rear rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Rear  .
scientia non olet · About LEMON Manuals