LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (TrailBlazer EXT, Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a flat-bladed tool to remove door sill plates from top of rocker molding.
    Fig 1: Removing/Installing Door Sill Plates
    GM831925Courtesy of GENERAL MOTORS CORP.
  2. Remove screw (1) from front of rocker panel molding.
    Fig 2: Removing/Installing Rocker Panel Molding Screws & Push-In Retainers
    GM831929Courtesy of GENERAL MOTORS CORP.
  3. Release the push-in retainers (2) from the lower rocker panel molding using a trim removal tool.
  4. Remove upper push in retainer (3).
    5. NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  5. Remove the rocker panel molding from the rocker panel.
scientia non olet · About LEMON Manuals