LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the trim to the tail lamp, ensuring that the retaining tabs are fully seated.
  2. Install the tail lamp assembly to the vehicle. Refer to TAIL LAMP REPLACEMENT in Lighting Systems.
    Fig 1: Removing/Installing Tail Lamp Trim
    GM741241Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals