LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Wheel Opening >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 6 push-pins that secure the wheel opening molding to the fender.
    IMPORTANT: Be careful not to scratch or chip the paint.
  2. Remove the molding.
    1. Heat the wheel opening molding using aJ 25070  . Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for about 30 seconds.

    2. Peel the wheel opening molding from the panel surface using a flat-bladed tool.
    Fig 1: Removing/Installing Wheel Opening Molding Push-Pins
    GM752097Courtesy of GENERAL MOTORS CORP.
  3. Remove all adhesive from the fender and the back of the molding using a 3M(tm) Scotch Brite molding adhesive remover disk 3M(tm) P/N 07501 or equivalent.
scientia non olet · About LEMON Manuals