LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1695 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Door Body Side (Chevrolet, GMC) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Do not touch the adhesive surface.
  1. Ensure the painted body surface in the tape contact area is clean and dry.
  2. Warm body panel with a heat lamp or heat gun (if necessary) to a temperature between 18.8-41.1°C (66-100°F).
  3. Remove the tape liner from the adhesive tape.
  4. Ensure that the molding is aligned with the body panel. Press the door side molding to the body panel.
    Fig 1: Removing/Installing Front Door Body Side Molding (Chevrolet, GMC)
    GM752100Courtesy of GENERAL MOTORS CORP.
  5. Hand roll the door side molding to the body in order to ensure proper adhesion.
scientia non olet · About LEMON Manuals