Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Heat the mounting surface to approximately 27-41°C (80-105°F).
- Ensure that the temperature of the slats is approximately 29-32°C (85-90°F).
- Remove the backing from the adhesive on the slats.
- Align the luggage carrier slats with the masking tape.
- Install the luggage carrier slats to the vehicle.
- Apply equal pressure along the slats in order to uniformly bond the item to the mounting surface.
- Remove the masking tape from the vehicle.
IMPORTANT:
Apply the slats in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
IMPORTANT:
Do NOT touch the adhesive backing.