LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Step Pad Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Bumper Step Pad
    GM347053Courtesy of GENERAL MOTORS CORP.
  1. Install the step pad to the bumper by pushing down on the clips.
  2. Insert the side molding push-pins.
  3. Install the bumper. Refer to Bumper Replacement - Rear  .
scientia non olet · About LEMON Manuals