LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (Utility) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Rear Bumper Fascia (Utility)
    GM316187Courtesy of GENERAL MOTORS CORP.
  1. Remove the top fascia retainers.
  2. Disconnect the license plate lamp harness.
  3. Raise and support the vehicle with suitable safety stands. Refer to LIFTING & JACKING THE VEHICLE .
  4. Remove the Spare Tire Wheel Hoist Guide Retaining Clips. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  5. Remove the push-pin retainers from the underside of the fascia.
  6. Remove the fascia from the impact bar.
scientia non olet · About LEMON Manuals