LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (Utility) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the locator pin of the fascia to the hole in the impact bar.
    2. Fig 1: Installing Rear Bumper Fascia (Utility)
    GM316187Courtesy of GENERAL MOTORS CORP.
  2. Press the push-pin retainers into the underside of the fascia.
  3. Install the Spare Tire Wheel Hoist Guide Retaining Clips. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  4. Remove the safety stands, and lower the vehicle.
  5. Connect the license plate lamp harness.
  6. Install the top fascia retainers.
scientia non olet · About LEMON Manuals