LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (Escalade EXT) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear license plate and attaching hardware from the rear bumper.
  2. Remove the spare tire wheel hoist guide and retaining clip. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  3. Remove the top fascia step pads. Refer to Step Pad Replacement - Top Rear Bumper  .
  4. Remove the center fascia step pad. Refer to Step Pad Replacement - Center Rear Bumper  .
  5. Remove the rear object sensors. Refer to REAR OBJECT SENSOR REPLACEMENT .
    6. Fig 1: Removing Rear Bumper Fascia (Escalade EXT)
    GM820663Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear fascia from the bumper bar.
scientia non olet · About LEMON Manuals