LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (Avalanche) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Bumper Fascia (Avalanche)
    GM820663Courtesy of GENERAL MOTORS CORP.
  1. Install the fascia onto the impact bar.
  2. Install the retainers into the underside of the fascia.
  3. Install the Spare Wheel Hoist Guide Shaft from vehicle. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  4. Install the Center Step Pad. Refer to Step Pad Replacement - Center Rear Bumper  .
  5. Install the Left/Right Side Step pads. Refer to Step Pad Replacement - Top Rear Bumper  .
  6. Install the Left/Right Side Step pads. Refer to Step Pad Replacement - Side Rear Bumper  .
scientia non olet · About LEMON Manuals