LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper (Avalanche) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fascia & Retainers
    GM800541Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to LIFTING & JACKING THE VEHICLE .
  2. Remove the brace bolt. Refer to Brace Replacement - Front Bumper (Avalanche)  .
  3. Remove the retainers (2) from the fascia (1).
  4. Remove the daytime running and fog lamps. Refer to DAYTIME RUNNING AND FOG LAMP ASSEMBLY REPLACEMENT (AVALANCHE) .
    5. Fig 2: Front Fender Outer Panel Clips
    GM741570Courtesy of GENERAL MOTORS CORP.
  5. Release the front fascia locking fittings from the radiator grille support.
  6. Pull the front fascia in order to release the front fascia from the front fender outer panel clips (1).
scientia non olet · About LEMON Manuals