LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Bumper Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting License Plate Lamp Harness
    GM406215Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the license plate lamp harness.
    2. Fig 2: Impact Bar Nut, Plate Nuts & Bracket Bolts
    GM379246Courtesy of GENERAL MOTORS CORP.
  2. Remove the impact bar nut (1).
  3. Remove the plate nuts (2).
  4. Remove the lower frame rail to bracket bolt (3).
  5. Remove the side frame rail to bracket bolt (4).
    6. Fig 3: Bumper Bolts
    GM393110Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear trailer hitch to bumper bolts (1), if equipped.
  7. Remove the rear bumper from the vehicle.
scientia non olet · About LEMON Manuals