LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Bracket Replacement - Front Bumper (2500)

Bracket Replacement - Front Bumper (2500)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Bolts
    GM671498Courtesy of GENERAL MOTORS CORP.
  1. Remove all related panels and components.
  2. Remove the damaged bumper bracket.
  3. Visually inspect the frame and restore all damage to factory specifications using 3-dimensional measuring.
    4. IMPORTANT: If the vehicle is equipped with tow hooks, discard original fasteners.
  4. Align the replacement bracket lower bolt holes with tow hook mounting locations and install the bolts (1) supplied.
  5. Align the front edge of bracket with front edge of frame and mark upper bolt locations (1) on frame.
    Fig 2: Upper Bolt Locations
    GM671426Courtesy of GENERAL MOTORS CORP.
    6. Fig 3: Drilling Holes In Frame
    GM671416Courtesy of GENERAL MOTORS CORP.
  6. Rotate the bracket forward and drill 13 mm (1/2 in) holes in frame at upper bolt locations.
  7. Rotate the bracket back into position.
    8. Fig 4: Rotating Bracket Into Position
    GM671509Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  8. Install the fasteners supplied.

    Tighten:  Tighten the torque bracket fasteners to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals