LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1691 (Bumper System) >> Repair Instructions >> Bracket Replacement - Front Bumper (1500)

Bracket Replacement - Front Bumper (1500)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Front Bumper Bracket (1500)
    GM671616Courtesy of GENERAL MOTORS CORP.
  1. Remove all related panels and components.
  2. Remove damaged bumper bracket.
    3. IMPORTANT: Do not remove any material from end of frame rail.
  3. Position the service template on the end of the frame rail. Use 3M's Repositionable Adhesive or equivalent.
  4. Drill three 13 mm (1/2 in) holes at locations indicated on template.
    5. IMPORTANT: Prior to refinishing, refer to the Publication GM 4901M-D-2000 "GM Approved Refinish Materials" for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.
  5. Apply approved anti-corrosion primer to bare metal surfaces.
  6. Position replacement bumper bracket.
    7. NOTE: Refer to FASTENER NOTICE .
  7. Install the bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals