LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1690 (Stationary Window System) >> Repair Instructions >> Windshield Upper Reveal Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to GLASS & SHEET METAL HANDLING CAUTION .
  1. Remove both right and left sides of the reveal molding. Refer to Windshield Side Reveal Molding Replacement .
    2. Fig 1: View Of Window Reveal Molding
    GM301108Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The windshield reveal molding fills the cavities between the body and windshield. If the reveal molding is stretched or damaged, replace the molding.
  2. Remove the upper windshield reveal molding.
    1. Use a flat-bladed tool in order to carefully pry the end of the upper reveal molding out about 76 mm (3 in).
    2. Grasp the corner of the windshield reveal molding by hand or use a suitable tool to slowly pull the molding away from the windshield.
    3. If the molding will not release, use a utility knife to release the molding.
scientia non olet · About LEMON Manuals