Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the top edge of the windshield surface with a 50/50 mixture of isopropyl alcohol and water on a dampened lint-free cloth.
- Fit the new reveal molding to the windshield prior to installation.
- Verify that all primers and urethane adhesive are within expiration dates.
- Use a new dauber in order to apply glass prep (clear #1) to the channel area approximately 13 mm (1/2 in) to the upper edge of the windshield.
- Wipe the glass primed area immediately with a clean lint-free cloth.
- Shake the glass primer (black #2) for at least 1 minute. Use a new dauber to apply the primer to the top edge of the windshield.
- Apply a small bead of urethane adhesive (2) between the windshield (1) and the pinchweld.
- Install the upper reveal molding.
- Start from the center and hand-press the reveal molding into place over the edge of the windshield.
- Install the right and the left sides of the reveal molding. Refer to Windshield Side Reveal Molding Replacement .
- Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
- Apply the tape in order to retain the reveal molding to the windshield. This will maintain a flush fit with the body.
- Remove the tape after 6 hours.
CAUTION:
Refer to WINDOW RETENTION CAUTION
.
IMPORTANT:
Apply the prep (clear #1) to the windshield carefully. The primer dries almost instantly, and may stain the viewing area of the windshield if not applied evenly.