Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to WINDOW RETENTION CAUTION .

Verify all primers and urethane adhesive are within expiration dates.

Fig 1: Applying Glass Primer (Black #2)

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use care when applying the prep, clear #1, to the window. This primer dries almost instantly, and may stain the viewing area of the window if not applied evenly.

Use a new dauber in order to apply glass prep, clear #1, to the channel area approximately 13 mm (1/2 in) to the upper edge of the window.
Wipe the glass primed area immediately with a clean lint-free cloth.
Shake the glass primer, black #2, for at least 1 minute.
Use a new dauber in order to apply glass primer, black #2, to the top edge of the window.

Fig 2: Applying Urethane Adhesive Between Window & Pinch-Weld

Courtesy of GENERAL MOTORS CORP.

Apply a small bead of urethane adhesive (2) between the window (1) and the pinch-weld.

Fig 3: View Of Window Reveal Molding

Courtesy of GENERAL MOTORS CORP.

Reinstall the window reveal molding.
1. Start from the loose area and hand-press the reveal molding into place over the edge of the window.
2. Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
3. Tape should be applied in order to retain the reveal molding to the window. This will maintain a flush fit with the body.
4. The tape is to be removed after 6 hours.