LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1686 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the rear side hood seal from the pinchweld flange and motor compartment flange.
  3. Remove the rear side hood seal from the vehicle.
  4. Clean any adhesive from the pinch-weld flange and motor compartment flange surface using 3M™ P/N 8984 Adhesive Remover.
    5. Fig 1: Removing Rear Side Hood Seal From Pinchweld Flange And Motor Compartment Flange
    G01587883Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals