Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Open and support the hood.
Lift the retainer clips on the assist rod using a small flat-bladed tool.

Fig 1: Lifting Retainer Clips On Assist Rod
Courtesy of GENERAL MOTORS CORP.

NOTE: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
Pull the upper end of the assist rod from the ball joint on the hood.
Pull the lower end of the assist rod from the ball joint on the lower hood hinge.

Fig 2: Removing Assist Rod Lower And Upper End

Courtesy of GENERAL MOTORS CORP.