LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Lighting Systems) >> Repair Instructions >> Daytime Running Lamps (DRL) Ambient Light Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the garnish molding from the right windshield pillar. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR in Interior Trim.
  2. Starting at the right side, carefully lift upwards on the instrument panel (IP) upper trim panel in order to release the retainers from the IP upper trim pad. Work towards the left in order to access the daytime running lamp (DRL) ambient light sensor (1).
    Fig 1: Accessing Daytime Running Lamp Ambient Light Sensor
    G01587066Courtesy of GENERAL MOTORS CORP.
  3. Remove the DRL ambient light sensor from the IP upper trim panel by twisting the sensor 1/4 turn counterclockwise.
  4. Remove the DRL ambient light sensor from the DRL ambient light sensor connector.
scientia non olet · About LEMON Manuals