LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Lighting Systems) >> Repair Instructions >> Daytime Running Lamps (DRL) Ambient Light Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the daytime running lamp (DRL) ambient light sensor (1) to the DRL ambient light sensor connector.
  2. Position the DRL ambient light sensor to the opening in the instrument panel (IP) upper trim panel. Twist the DRL ambient light sensor 1/4 turn clockwise.
  3. Verify that the DRL ambient light sensor wiring harness will not be pinched when the IP upper trim panel is installed. Working from left to right, press down on the IP upper trim panel in order to engage the retainers to the IP upper trim pad.
    Fig 1: Installing Daytime Running Lamp Ambient Light Sensor
    G01587067Courtesy of GENERAL MOTORS CORP.
  4. Install the garnish molding to the right windshield pillar. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR in Interior Trim.
scientia non olet · About LEMON Manuals