LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1676 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil level indicator tube.
    • Lubricate the O-ring with engine oil and make sure it is in place.
    • Make sure the assembly is fully seated in the engine block.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the oil level indicator tube nut.

    Tighten 

    Tighten the nut to 19 N.m (14 lb ft).

  3. Install the oil level indicator.
    Fig 1: Installing Oil Level Indicator, Nut & Tube
    G01969527Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals